Installation Guide

About 2 minutes per door. No wiring, no coding.

The 3 steps

  1. Step 1: Pop out the factory light

    Open the door and find the light on the bottom edge of the panel. Slide a plastic trim tool into the gap at the notched end and gently lever down. Plastic only: metal tools scratch the panel.

  2. Step 2: Swap the plug

    Press the clip on the connector to unplug the factory light, then plug in DoorGlow. The connector only fits one way.

  3. Step 3: Click it in and test

    Push DoorGlow into the door, connector end first, until it sits flush. Close and reopen the door: your logo lights the ground. Upside down? Unclip it, turn it 180° and click it back in.

DoorGlow lights replace your car's factory courtesy (puddle) lights. No wiring, no cutting, no coding — about 2 minutes per door. Repeat the 3 steps above on each door.

What you need

  • Your DoorGlow lights
  • A plastic trim tool or flat plastic pry tool. Don't use metal tools — they scratch the panel.

Tips

  • The factory light has a small notch at one end: that's where the tool goes in.
  • The connector only fits one way, and DoorGlow goes back in connector end first.
  • If the design looks upside down, unclip the light, rotate it 180°, and click it back in.
  • If a light doesn't turn on, check the connector is fully seated. Still nothing? Try it in another door to rule out the car, then contact us.
  • Keep your factory lights — you'll want them if you sell the car.